How do I set the grid type on the power meter?

  • Updated

Setting the correct grid on the power meter is necessary but also not intuitive.

  1. Hold down the menu key on the power meter for 3 seconds to enter programming mode.
  2. Press the right arrow key six times to access the grid system screen. It looks like this:
    an image of an LCD screen from a power meter.
  3. Hold down the menu key for 3 seconds to activate edit mode.
  4. Use the menu key to select your grid.
    • For a 3-phase TN-system grid, select 4-3Ph.
    • For a 3-phase IT-system grid, select 3-3Ph.
  5. Exit the edit mode by holding down the menu key for 3 seconds.
  6. Hold down the right arrow key to exit programming mode.

Was this article helpful?

2 out of 13 found this helpful